233 lines
6.3 KiB
C
233 lines
6.3 KiB
C
/***************************************************************************
|
|
* __________ __ ___.
|
|
* Open \______ \ ____ ____ | | _\_ |__ _______ ___
|
|
* Source | _// _ \_/ ___\| |/ /| __ \ / _ \ \/ /
|
|
* Jukebox | | ( <_> ) \___| < | \_\ ( <_> > < <
|
|
* Firmware |____|_ /\____/ \___ >__|_ \|___ /\____/__/\_ \
|
|
* \/ \/ \/ \/ \/
|
|
* $Id$
|
|
*
|
|
* Copyright (C) 2009 by Michael Sevakis
|
|
* Copyright (C) 2008 by Bertrik Sikken
|
|
*
|
|
* This program is free software; you can redistribute it and/or
|
|
* modify it under the terms of the GNU General Public License
|
|
* as published by the Free Software Foundation; either version 2
|
|
* of the License, or (at your option) any later version.
|
|
*
|
|
* This software is distributed on an "AS IS" basis, WITHOUT WARRANTY OF ANY
|
|
* KIND, either express or implied.
|
|
*
|
|
****************************************************************************/
|
|
#include "config.h"
|
|
#include "system.h"
|
|
#include "thread.h"
|
|
#include "as3514.h"
|
|
#include "ascodec.h"
|
|
#include "adc.h"
|
|
#include "powermgmt.h"
|
|
#include "power.h"
|
|
#include "usb.h"
|
|
|
|
/*===========================================================================
|
|
* These parameters may be defined per target:
|
|
*
|
|
* BATT_FULL_VOLTAGE - Upon connect a charge cycle begins if the reading is
|
|
* lower than this value (millivolts).
|
|
*
|
|
* BATT_VAUTO_RECHARGE - While left plugged after cycle completion, the
|
|
* charger restarts automatically if the reading drops
|
|
* below this value (millivolts). Must be less than
|
|
* BATT_FULL_VOLTAGE.
|
|
*
|
|
* ADC_BATTERY - ADC channel from which to read the battery voltage
|
|
*
|
|
* BATT_CHG_V - Charger voltage regulation setting (as3514 regval)
|
|
*
|
|
* BATT_CHG_I - Charger current regulation setting (as3514 regval)
|
|
*
|
|
* CHARGER_TOTAL_TIMER - Maximum allowed charging time (1/2-second steps)
|
|
*===========================================================================
|
|
*/
|
|
|
|
/* This code assumes USB power input is not distinguishable from main
|
|
* power and charger connect cannot wait for USB configuration before
|
|
* considering USB charging available. Where they are distinguishable,
|
|
* things get more complicated. */
|
|
static bool charger_close = false; /* Shutting down? */
|
|
static int charger_total_timer = 0; /* Timeout in algorithm steps */
|
|
|
|
/* Current battery threshold for (re)charge:
|
|
* First plugged = BATT_FULL_VOLTAGE
|
|
* After charge cycle or non-start = BATT_VAUTO_RECHARGE
|
|
*/
|
|
static unsigned int batt_threshold = 0;
|
|
|
|
/* ADC should read 0x3ff=5.12V */
|
|
/* full-scale ADC readout (2^10) in millivolt */
|
|
|
|
/* Returns battery voltage from ADC [millivolts] */
|
|
int _battery_voltage(void)
|
|
{
|
|
return (adc_read(ADC_BATTERY) * 5125 + 512) >> 10;
|
|
}
|
|
|
|
/* Returns true if the unit is charging the batteries. */
|
|
bool charging_state(void)
|
|
{
|
|
return charge_state == CHARGING;
|
|
}
|
|
|
|
/* Reset the battery filter to a new voltage */
|
|
static void battery_voltage_sync(void)
|
|
{
|
|
int i;
|
|
unsigned int mv;
|
|
|
|
for (i = 0, mv = 0; i < 5; i++)
|
|
mv += _battery_voltage();
|
|
|
|
reset_battery_filter(mv / 5);
|
|
}
|
|
|
|
/* Disable charger and minimize all settings. Reset timers, etc. */
|
|
static void disable_charger(void)
|
|
{
|
|
ascodec_write_charger(TMPSUP_OFF | CHG_OFF);
|
|
|
|
if (charge_state > DISCHARGING)
|
|
charge_state = DISCHARGING; /* Not an error state already */
|
|
|
|
charger_total_timer = 0;
|
|
battery_voltage_sync();
|
|
}
|
|
|
|
/* Enable charger with specified settings. Start timers, etc. */
|
|
static void enable_charger(void)
|
|
{
|
|
ascodec_write_charger(BATT_CHG_I | BATT_CHG_V);
|
|
|
|
sleep(HZ/10); /* Allow charger turn-on time (it could be gradual). */
|
|
|
|
#if CONFIG_CPU != AS3525v2
|
|
/* acknowledge first end of charging interrupt, it seems to happen both
|
|
* at charger plug and charger unplug
|
|
* It doesn't happen on newer AS3543
|
|
*/
|
|
ascodec_endofch();
|
|
#endif
|
|
|
|
charge_state = CHARGING;
|
|
charger_total_timer = CHARGER_TOTAL_TIMER;
|
|
battery_voltage_sync();
|
|
}
|
|
|
|
void powermgmt_init_target(void)
|
|
{
|
|
/* Everything CHARGER, OFF! */
|
|
ascodec_monitor_endofch();
|
|
ascodec_write_charger(TMPSUP_OFF | CHG_OFF);
|
|
}
|
|
|
|
static inline void charger_plugged(void)
|
|
{
|
|
batt_threshold = BATT_FULL_VOLTAGE; /* Start with topped value. */
|
|
battery_voltage_sync();
|
|
}
|
|
|
|
static inline void charger_control(void)
|
|
{
|
|
switch (charge_state)
|
|
{
|
|
case DISCHARGING:
|
|
{
|
|
unsigned int millivolts;
|
|
unsigned int thresh = batt_threshold;
|
|
|
|
if (BATT_FULL_VOLTAGE == thresh)
|
|
{
|
|
/* Wait for CHG_status to be indicated. */
|
|
if (!ascodec_chg_status())
|
|
break;
|
|
|
|
batt_threshold = BATT_VAUTO_RECHARGE;
|
|
}
|
|
|
|
millivolts = battery_voltage();
|
|
|
|
if (millivolts <= thresh)
|
|
enable_charger();
|
|
break;
|
|
} /* DISCHARGING: */
|
|
|
|
case CHARGING:
|
|
{
|
|
if (!ascodec_endofch())
|
|
{
|
|
if (--charger_total_timer > 0)
|
|
break;
|
|
|
|
/* Timer ran out - require replug. */
|
|
charge_state = CHARGE_STATE_ERROR;
|
|
}
|
|
/* else end of charge */
|
|
|
|
disable_charger();
|
|
break;
|
|
} /* CHARGING: */
|
|
|
|
default:
|
|
/* DISABLED, ERROR */
|
|
break;
|
|
}
|
|
}
|
|
|
|
static inline void charger_unplugged(void)
|
|
{
|
|
disable_charger();
|
|
if (charge_state >= CHARGE_STATE_ERROR)
|
|
charge_state = DISCHARGING; /* Reset error */
|
|
}
|
|
|
|
/* Main charging algorithm - called from powermgmt.c */
|
|
void charging_algorithm_step(void)
|
|
{
|
|
switch (charger_input_state)
|
|
{
|
|
case NO_CHARGER:
|
|
/* Nothing to do */
|
|
break;
|
|
|
|
case CHARGER_PLUGGED:
|
|
charger_plugged();
|
|
break;
|
|
|
|
case CHARGER:
|
|
charger_control();
|
|
break;
|
|
|
|
case CHARGER_UNPLUGGED:
|
|
charger_unplugged();
|
|
break;
|
|
}
|
|
|
|
if (charger_close)
|
|
{
|
|
/* Disable further charging and ack. */
|
|
charge_state = CHARGE_STATE_DISABLED;
|
|
disable_charger();
|
|
charger_close = false;
|
|
}
|
|
}
|
|
|
|
/* Disable the charger and prepare for poweroff - called off-thread so we
|
|
* signal the charging thread to prepare to quit. */
|
|
void charging_algorithm_close(void)
|
|
{
|
|
charger_close = true;
|
|
|
|
/* Power management thread will set it false again. */
|
|
while (charger_close)
|
|
sleep(HZ/10);
|
|
}
|